Teldat bintec R3002 Manual page 333

Table of Contents

bintec Rxxx2/RTxxx2

Proxy ARP Mode

button to edit the configuration of the corresponding leased line for a PRI

(default value): OSPF is not activated for this inter-

face, i.e. no OSPF protocol packets sent over this interface.

Networks reachable over this interface are, however, included

when calculating the routing information and propagated over

active interfaces.

: OSPF is not activated for this interface, i.e. OSPF

protocol packets sent over this interface.

: OSPF is disabled for this interface.

Select whether and how ARP requests are to be responded to

for the specified connection partner.

Possible values:

(default value): Deactivates Proxy ARP for this

connection partner.

: Your device only responds to an ARP re-

quest if the status of the connection to the connection partner

. In the case of

sponds to the ARP request; the connection is not set up until

someone actually wants to use the route.

: Your device responds to an ARP request only if the

status of the connection to the connection partner is

connection already exists to the connection partner.

, your device only re-

Show Quick Links

Table of Contents