Teldat bintec R3002 Manual page 426

Table of Contents

Registration

Fields in the Trunk Settings menu.

SIP Header Field(s) for

Caller Address

In SIP server mode: Define a PIN or a password.

A maximum of 40 characters can be entered.

Specify whether the registration mechanism is to be used by

SIP REGISTER. Normally, every SIP client (user) sends its cur-

rent position to a REGISTRAR server by means of a RE-

GISTER message. This information about the user and his cur-

rent address is held by the REGISTRAR server and queried by

other proxies to find the user.

The function is enabled with

The function is enabled by default.

Apart from this standard procedure, the relevant data can also

be sent to a particular IP address that is already known to the

correspondent. Registration and authentication are not then

needed and the Registration function is disabled. An example

of this method is Microsoft Exchange SIP.

Only if Registration is enabled.

Enter the time in seconds after which the current registration be-

comes invalid and a new registration request is therefore sent.

Possible values are

The default value is

In answer to a REGISTER request, a server can set another Ex-

pire Time which overwrites the setting here.

Only for Trunk Mode =

Select the position of the sender ID (e.g. subscriber number) in

the SIP header for outgoing calls. (For incoming calls, the sub-

scriber number is taken automatically from the SIP header.)

Possible values:

(default value): the sender ID is not sent.

bintec Rxxx2/RTxxx2

Show Quick Links

Table of Contents