Teldat bintec R3002 Manual page 135

Table of Contents

bintec Rxxx2/RTxxx2

Incoming Service Type Only for AUX Port Status = enabled

SIM Card Uses PIN

Modem Escape Char-

Modem Init Sequence

APN (Access Point

logue modem.

Here you select the gateway subsystem to which an incoming

call over the modem is to be assigned.

Possible values:

: No call is accepted.

: The call is assigned to the ISDN Login subsys-

(default value): The call is assigned to the PPP

Only for AUX Port Status = enabled

Here you enter the PIN of your GSM modem, if your modem

asks for it.

Entering a wrong PIN blocks communication with the modem

until the entry in the profile is corrected.

Only for AUX Port Status = enabled

The value for this field is set by default to . It should only be

changed if the escape character of the modem is different.

Only for AUX Port Status = enabled

Here you can enter an initialization string for your modem. The

command ATX3&K3\V1 is the default setting (the modem does

not wait for a free signal before dialling).

You can add other AT commands by separating them with

semicolons. The entry is limited to 50 characters. Make sure

you enter the command for activating the XON/XOFF software

flow control. This is proprietary and cannot be set automatically.

The command sequence can be obtained from your modem

manual or the manufacturer.

Only for AUX Port Status = enabled

If GPRS is used, the so-called Access Point Name of the pro-

11 Physical Interfaces

Show Quick Links

Table of Contents