Teldat bintec R3002 Manual page 389

Table of Contents

bintec Rxxx2/RTxxx2

IP Assignment Pool

The menu Advanced Settings consists of the following fields:

Fields in the Advanced Settings menu.

Block after connection

Authentication

: The lower the value, the higher the priority of the

route (possible values

Only if PPTP Mode =

Select a IP pool configured in the VPN->PPTP->IP Pools

Enter the wait time in seconds before the device should try

again after an attempt to set up a connection has failed.

The default value is

Select the authentication protocol for this PPTP partner.

Possible values:

: Only run PAP (PPP Password Authentication Protocol);

the password is transferred unencrypted.

: Only run CHAP (PPP Challenge Handshake Authentic-

ation Protocol as per RFC 1994); password is transferred en-

: Primarily run CHAP, otherwise PAP.

: Only run MS-CHAP version 1 (PPP Microsoft

Challenge Handshake Authentication Protocol).

: Give priority to CHAP, if refused use

the authentication protocol requested by the PPTP partner.

(MSCHAP version 1 or 2 possible.)

(default value): Run MS-CHAP version 2 only.

: Some providers use no authentication. In this case, se-

lect this option.

If necessary, select the type of encryption that should be used

for data traffic to the connection partner. If Encryption is set,

the remote terminal must also support it, otherwise a connection

cannot be set up.

). The default value is .

, IP Address Mode =

Show Quick Links

Table of Contents