Teldat bintec R3002 Manual page 367

Table of Contents

bintec Rxxx2/RTxxx2

IP Compression

Propagate PMTU

Select whether compression is to be activated before data en-

cryption. If data is compressed effectively, this can result in

higher performance and a lower volume of data to be trans-

ferred. In the case of fast lines or data that cannot be com-

pressed, you are advised against using this option as the per-

formance can be significantly affected by the increased effort

during compression.

The function is enabled with

The function is disabled by default.

Select whether and how IPSec heartbeats are used.

A Teldat IPSec heartbeat is implemented to determine whether

or not a Security Association (SA) is still valid. This function

sends and receives signals every 5 seconds, depending on the

configuration. If these signals are not received after 20 seconds,

the SA is discarded as invalid.

Possible values:

(default value): Automatic detection of whether

the remote terminal is a Teldat device. If it is,

(for a remote terminal with Teldat) or

(for a remote terminal without Teldat) is set.

: Your device sends and expects no heartbeat. Set

this option if you use devices from other manufacturers.

heartbeat from the peer but does not send one itself.

: Your device expects no heartbeat from the peer, but

sends one itself.

heartbeat from the peer and sends one itself.

Select whether the PMTU (Path Maximum Transfer Unit) is to

be propagated during phase 2.

The function is enabled with

The function is enabled by default.

: Your device expects a

Show Quick Links

Table of Contents