Teldat bintec R3002 Manual page 222

Table of Contents

14 Networking

Distribution Policy

Fields in the Interface Selection for Distribution menu.

Distribution Ratio

The menu Advanced Settings consists of the following fields:

Fields in the Advanced Settings menu.

Route Selector

Displays the type of data traffic selected.

Select the interfaces that are to belong to the group from the

available interfaces.

Enter the percentage of the data traffic to be assigned to an in-

The meaning differs according to the Distribution Ratio em-

uted sessions.

cisive factor.

The Route Selector parameter is an additional criterion to help

define a load balancing group more precisely. Here, routing in-

formation is added to the "interface" entry within a load balan-

cing group. The route selector is required in certain scenarios to

enable the IP sessions managed by the router to be balanced

uniquely for each load balancing group. The following rules ap-

ply when using the parameter:

• If an interface is only assigned to one load balancing group, it

is not necessary to configure the route selector.

• If an interface is assigned to multiple load balancing groups,

configuration of the route selector is essential.

• The route selector must be configured identically for all inter-

face entries within a load balancing group.

Select the Destination IP Address of the desired route.

is based on the number of distrib-

, the data rate is the de-

bintec Rxxx2/RTxxx2

Show Quick Links

Table of Contents