Teldat bintec R3002 Manual page 605

Teldat GmbH
bintec Rxxx2/RTxxx2
Signalling 1) phones.
V.11 ITU-T recommendation for balanced dual-current interface lines (up
to 10 mbps).
V.24 CCITT and ITU-T recommendation that defines the interface
between a PC or terminal as Data Terminal Equipment (DTE) and a
modem as Data Circuit-terminating Equipment (DCE).
V.28 ITU-T recommendation for unbalanced dual-current interface line.
V.35 ITU-T recommendation for data transmission at 48kbps in the range
from 60 to 108kHz.
V.36 Modem for V.35.
V.42bis Data compression procedure.
V.90 ITU standard for 56 kbps analogue modems. In contrast to older
V.34 modems, data is sent in digital form to the client when the V.90
standard is used and does not need to be first converted from digital
to analogue on one side of the modem (provider), as was the case
with V.34 and earlier modems. This makes higher transmission
rates possible. A maximum speed of 56 kbps can be achieved only
under optimum conditions.
Vanity Letter dialling
VDSL Very high bit rate digital subscriber line (also called VADSL or BD-
SL).
VID VLAN ID
VJHC Van Jacobson Header Compression
VLAN Virtual LAN
VoIP Voice over IP
VPN Virtual Private Network
VSS Virtual Service Set
WAN Wide Area Network
WAN interface WAN interface
WAN partner Remote station that is reached over a WAN, e.g. ISDN.
Glossary
591