Teldat bintec R3002 Manual page 326

17 WAN
312
Note
Generally, monitoring is not carried out by the terminal but is initiated by the ISP. Your
device then only needs to react correctly to the signals received. This is ensured
without a specific OAM configuration for both flow level 4 and flow level 5.
Two mechanisms are available for monitoring the ATM connection: Loopback Tests and
OAM Continuity Check (OAM CC). These can be configured independently of each other.
Caution
The configuration of OAM requires extensive knowledge of ATM technology and the
way the Teldat devices functions. An incorrect configuration can cause considerable
disruption during operation. If applicable, save the original configuration on your PC.
In the WAN->ATM->OAM Controlling menu, a list of all monitored OAM flow levels is dis-
played.
17.2.3.1 New
Choose the New button to set up monitoring for other flow levels.
WAN ATM OAM Controlling
Fig. 124: -> ->
The menu WAN->ATM->OAM Controlling->New consists of the following fields:
Fields in the OAM Flow Configuration menu.
New
->
Teldat GmbH
bintec Rxxx2/RTxxx2