Ethernet Ports - Teldat bintec R3002 Manual

Table of Contents

11 Physical Interfaces

11.2 Ethernet Ports

An Ethernet interface is a physical interface for connection to the local network or external

The Ethernet ports ETH1 to ETH4 are assigned to a single logical Ethernet interface in ex

works state. The logical Ethernet interface

The logical Ethernet interface

To ensure your device can be reached, when splitting ports make sure that Ethernet

is assigned - with the preconfigured IP address and netmask - to a

port that can be reached via Ethernet. If in doubt, carry out the configuration using a

serial connection via the Console interface.

The interfaces can be used separately. They are logically separated from each other, each

separated port is assigned the desired logical Ethernet interface in the Ethernet Interface

Selection field of the Port Configuration menu. For each assigned Ethernet interface, an-

other interface is displayed in the list in the LAN->IP Configuration menu, and the inter-

face can be confugred completely independently.

By default, the logical Ethernet interface

ation options are the same as those for the ports ETH1 - ETH4.

vider must be entered, e.g. internet.eplus.de for eplus and so

A maximum of 40 characters can be entered. If no APN or an

incorrect APN is entered, a configured GPRS connection will

not function.

is assigned and is preconfigured with the

is assigned to the ETH5 port and is not precon-

is assigned to the ETH5 port. The configur-

bintec Rxxx2/RTxxx2

Show Quick Links

Table of Contents