Messages Displayed On The Client Computer - Ricoh pro c900s Operating Instructions Manual

3. Troubleshooting When Using the Scanner Function
Message
"Some of selected files are
currently in use. They could
not be deleted."
"The selected file(s)
contained file(s) without
access privileges. Only file(s)
3
with access privileges will be
deleted."
"Transmission has failed. To
check the current status, press
[Scanned Files Status]."
"Updating the destination list
has failed. Try again?"
"You do not have the
privileges to use this function."

Messages Displayed on the Client Computer

This section describes likely causes of and possible solutions for the main error messages displayed on the
client computer when using the TWAIN driver.
• If a message not described here appears, take necessary solutions specified by the message. For
information about how to turn off the main power switch, see "Turning On/Off the Power", About This
Machine.
Message
"Cannot add any more
scanning mode."
50
Cause
You cannot delete a file
whose status is "Waiting..." or
that is being edited with
DeskTopBinder.
You do not have permission
to delete the selected file(s).
While a file was being sent,
a network error occurred
and the file could not be sent
correctly.
A network error occurred.
The logged in user does not
have permission to use the
selected function.
Cause
The maximum number of scan
modes is already registered.
Solution
Cancel transmission ("Waiting..." status
cleared) or the DeskTopBinder setting,
and then delete the file.
The files can be deleted by the file
administrator. To delete a file which you
are not authorized to delete, contact the
administrator.
Try the operation once more. If the
message is still shown, the network may
be busy. Contact the network
administrator. If multiple files were sent,
use the Scanned Files Status screen to
check which file was affected.
Check that the server has network
connectivity.
Contact the administrator about the
permission for the required function.
Solution
The maximum number of modes that can
be stored is 100. Delete unnecessary
modes.