Table of Contents
Advertisement
2.10 Connecting the CA62 Built-in Digital Communicator
The telephone line is connected to A and B terminals on
the CA62 Control Panel with no requirements to observe
polarity (Figure 14).
The telephone device is connected to A1 and B1 termi-
nals on the CA62 Control Panel with no requirements to
observe polarity (Figure 14).
The parameters of the digital communicator are engineer
programmed.
It is not necessary to install additional components if the
built-in communicator is not to be used.
2.11 Installing of VD60 voice dialer to CA62 Alarm Control Panel
The "VD60" Voice Telephone Dialer module supplements the СА62 Alarm Control Panel, which serves to transmit alarm
event messages to the user, under the form of eight pre-recorded voice messages, of up to 5 sec. each. Two message
types are supported - by zone or by event (see description of ADDRESS 6035).
Turn off the power supply in order to connect the PCB of the voice telephone dialer to the EXPAND socket of the CA62
Control Panel (1). Fix the PCB onto the pre-mounted plastic spacers (2). The telephone line should be connected to
terminals A and B of the СА62 Control Panel. Polarity need not be observed.
The telephone device can be connected to terminals A1 and B1 of the СА62 Control Panel with no need of observing
polarity.
The voice dialer can simultaneously operate with the built-in digital communicator.
The dialer has one LED status indicator - PLAY/RECORD and BUSY, and one single digit LED display indicating the
number of the current message. Use the MSG key to switch-over between messages. Use the PLAY key to reproduce
messages when the REC jumper is turned off, or to record when it is turned on. A speaker (8-16 ohms) for listening to
recorded messages can be connected to the SP socket.
The voice dialer parameters can be programmed in the engineering menu at ADDRESSES 603х.
Installation and Programming Manual - СА62 Alarm Control Panel
Figure 15. Installing the VD60 Voice Telephone Dialer.
Telephone line
Telephone device
Figure 14. Connecting the CA62 built-
in communicator
15
Advertisement
Table of Contents
