Dot1X Max-Reauth-Req - Edge-Core ES3528MV2 Management Manual

D
block-traffic
C
Interface Configuration
C
For guest VLAN assignment to be successful, the VLAN must be configured
and set as active (see the
guest VLAN for the port (see the
E
This command sets the maximum number of times that the switch sends
dot1x max-reauth-
an EAP-request/identity frame to the client before restarting the
req
authentication process. Use the no form to restore the default.
S
D
2
C
Interface Configuration
E
This command sets the maximum number of times the switch port will
dot1x max-req
retransmit an EAP request/identity packet to the client before it times out
the authentication session. Use the no form to restore the default.
S
EFAULT
M
OMMAND ODE
U
OMMAND SAGE
XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x intrusion-action guest-vlan
Console(config-if)#
YNTAX
dot1x max-reauth-req count
no dot1x max-reauth-req
count – The maximum number of requests (Range: 1-10)
EFAULT
M
OMMAND ODE
XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x max-reauth-req 2
Console(config-if)#
YNTAX
dot1x max-req count
no dot1x max-req
count – The maximum number of requests (Range: 1-10)
– 851 –
| Authentication Commands
C 24
HAPTER
vlan database command) and assigned as the
network-access guest-vlan
802.1X Port Authentication
command).