Edge-Core ES3528MV2 Management Manual page 1259

Table 162: Multicast VLAN Registration for IPv4 Commands (Continued)
Command
show mvr interface
show mvr members
show mvr profile
show mvr statistics
This command enables Multicast VLAN Registration (MVR) globally on the
mvr
switch. Use the no form of this command to globally disable MVR.
S
D
Disabled
C
Global Configuration
C
Only IGMP version 2 or 3 hosts can issue multicast join or leave messages.
If MVR must be configured for an IGMP version 1 host, the multicast
groups must be statically assigned using the
E
The following example enables MVR globally.
This command binds the MVR group addresses specified in a profile to an
mvr
MVR domain. Use the no form of this command to remove the binding.
associated-profile
S
D
Disabled
Function
Shows MVR settings for interfaces attached to the MVR
VLAN
Shows information about the current number of
entries in the forwarding database, or detailed
information about a specific multicast address
Shows all configured MVR profiles
Shows MVR protocol statistics for the specified
interface
YNTAX
[no] mvr
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
XAMPLE
Console(config)#mvr
Console(config)#
YNTAX
[no] mvr domain domain-id associated-profile profile-name
domain-id - An independent multicast domain. (Range: 1-5)
profile-name - The name of a profile containing one or more MVR
group addresses. (Range: 1-21 characters)
S
EFAULT ETTING
– 1259 –
| Multicast Filtering Commands
C 39
HAPTER
mvr vlan group
MVR for IPv4
Mode
PE
PE
PE
PE
command.