Ipv6 Mld Snooping Query-Interval - Edge-Core ES3528MV2 Management Manual

◆
E
This command configures the interval between sending MLD general
ipv6 mld snooping
queries. Use the no form to restore the default.
query-interval
S
D
125 seconds
C
Global Configuration
C
◆
◆
E
This command configures the maximum response time advertised in MLD
ipv6 mld snooping
general queries. Use the no form to restore the default.
query-max-
response-time
S
The querier will not start or will disable itself after having started if it
detects an IPv6 multicast router on the network.
XAMPLE
Console(config)#ipv6 mld snooping querier
Console(config)#
YNTAX
ipv6 mld snooping query-interval interval
no ipv6 mld snooping query-interval
interval - The interval between sending MLD general queries.
(Range: 60-125 seconds)
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
This command applies when the switch is serving as the querier.
An MLD general query message is sent by the switch at the interval
specified by this command. When this message is received by
downstream hosts, all receivers build an MLD report for the multicast
groups they have joined.
XAMPLE
Console(config)#ipv6 mld snooping query-interval 150
Console(config)#
YNTAX
ipv6 mld snooping query-max-response-time seconds
no ipv6 mld snooping query-max-response-time
seconds - The maximum response time allowed for MLD general
queries. (Range: 5-25 seconds)
– 1241 –
| Multicast Filtering Commands
C 39
HAPTER
MLD Snooping