Queue Weight - Edge-Core ES3528MV2 Management Manual

Service time is shared at the egress ports by defining scheduling
◆
weights for WRR, or for the queuing mode that uses a combination of
strict and weighted queuing. Service time is allocated to each queue by
calculating a precise number of bytes per second that will be serviced
on each round.
The specified queue mode applies to all interfaces.
◆
E
XAMPLE
The following example sets the queue mode to strict priority service mode:
Console(config)#queue mode strict
Console(config)#
R
ELATED

queue weight (1171)

show queue mode (1173)
This command assigns weights to the eight class of service (CoS) priority
queue weight
queues when using weighted queuing, or one of the queuing modes that
use a combination of strict and weighted queuing. Use the no form to
restore the default weights.
S
YNTAX
queue weight weight0...weight7
no queue weight
D
EFAULT
Weights 1, 2, 4, 6, 8, 10, 12, 14 are assigned to queues 0 - 7 respectively.
C
OMMAND
Global Configuration
C
OMMAND
This command shares bandwidth at the egress port by defining
◆
scheduling weights for Weighted Round-Robin, or for the queuing mode
that uses a combination of strict and weighted queuing
Bandwidth is allocated to each queue by calculating a precise number
◆
of bytes per second that will be serviced on each round.
C
OMMANDS
weight0...weight7 - The ratio of weights for queues 0 - 7
determines the weights used by the WRR scheduler. (Range: 1-255)
S
ETTING
M
ODE
U
SAGE
– 1171 –
| Class of Service Commands
C 37
HAPTER
Priority Commands (Layer 2)
(page 1170).