Table 105: Arp Acl Commands; Arp Acls - Edge-Core ES3528MV2 Management Manual

| Access Control Lists
C 26
HAPTER

ARP ACLs

ARP ACL
S
access-list arp
R C
ELATED OMMANDS
permit, deny (965)
mac access-group (968)
The commands in this section configure ACLs based on the IP or MAC
address contained in ARP request and reply messages. To configure ARP
ACLs, first create an access list containing the required permit or deny
rules, and then bind the access list to one or more VLANs using the
inspection vlan command

Table 105: ARP ACL Commands

Command Function
access-list arp Creates a ARP ACL and enters configuration mode
permit, deny Filters packets matching a specified source or
destination address in ARP messages
show access-list arp Displays the rules for configured ARP ACLs
This command adds an ARP access list and enters ARP ACL configuration
mode. Use the no form to remove the specified ACL.
S
YNTAX
[no] access-list arp acl-name
acl-name – Name of the ACL. (Maximum length: 16 characters)
D S
EFAULT ETTING
None
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
When you create a new ACL or enter configuration mode for an existing
◆
ACL, use the permit or deny command to add new rules to the bottom
of the list. To create an ACL, you must add at least one rule to the list.
To remove a rule, use the no permit or no deny command followed by
◆
the exact text of a previously configured rule.
An ACL can contain up to 128 rules.
◆
E
XAMPLE
Console(config)#access-list arp factory
Console(config-arp-acl)#
– 970 –
(page 936).
ip arp
Mode
GC
ARP-ACL
PE