Configuring Maintenance End Points - Edge-Core ES3528MV2 Management Manual

Figure 303: Configuring Detailed Settings for Maintenance Associations
Use the Administration > CFM (Configure MEP – Add) page to configure
C
ONFIGURING
Maintenance End Points (MEPs). MEPs, also called Domain Service Access
M
AINTENANCE
Points (DSAPs), must be configured at the domain boundary to provide
E P
ND OINTS
management access for each maintenance association.
CLI R
EFERENCES
"CFM Commands" on page 1319
◆
C
OMMAND
◆ CFM elements must be configured in the following order: (1)
maintenance domain at the same level as the MEP to be configured
(see
association within the domain (see
Associations"), and (3) finally the MEPs using the MEP List.
An interface may belong to more than one domain, or to different MAs
◆
in different domains.
To change the MEP's MA or the direction it faces, first delete the MEP,
◆
and then create a new one.
P
ARAMETERS
These parameters are displayed:
MD Index – Domain index. (Range: 1-65535)
◆
◆ MA Index – MA identifier. (Range: 1-2147483647)
MEP ID – Maintenance end point identifier. (Range: 1-8191)
◆
MEP Direction – Up indicates that the MEP faces inward toward the
◆
switch cross-connect matrix, and transmits CFM messages towards,
U
SAGE
"Configuring CFM Maintenance
– 531 –
| Basic Administration Protocols
C 14
HAPTER
Connectivity Fault Management
Domains"), (2) maintenance
"Configuring CFM Maintenance