Permit, Deny (Extended Ipv6 Acl) - Edge-Core ES3528MV2 Management Manual

| Access Control Lists
C 26
HAPTER
IPv6 ACLs
permit, deny
(Extended IPv6 ACL)
D S
EFAULT ETTING
None
C M
OMMAND ODE
Standard IPv6 ACL
C U
OMMAND SAGE
New rules are appended to the end of the list.
E
XAMPLE
This example configures one permit rule for the specific address
2009:DB9:2229::79 and another rule for the addresses with the network
prefix 2009:DB9:2229:5::/64.
Console(config-std-ipv6-acl)#permit host 2009:DB9:2229::79
Console(config-std-ipv6-acl)#permit 2009:DB9:2229:5::/64
Console(config-std-ipv6-acl)#
R C
ELATED OMMANDS
access-list ipv6 (958)
Time Range (762)
This command adds a rule to an Extended IPv6 ACL. The rule sets a filter
condition for packets with specific source or destination IP addresses, or
next header type. Use the no form to remove a rule.
S
YNTAX
{permit | deny} {any | host source-ipv6-address |
source-ipv6-address[/prefix-length]}
{any | destination-ipv6-address[/prefix-length]}
[dscp dscp] [next-header next-header]
[time-range time-range-name]
no {permit | deny} {any | host source-ipv6-address |
source-ipv6-address[/prefix-length]}
{any | destination-ipv6-address[/prefix-length]}
[dscp dscp] [next-header next-header]
any – Any IP address (an abbreviation for the IPv6 prefix ::/0).
host – Keyword followed by a specific source IP address.
source-ipv6-address - An IPv6 source address or network class. The
address must be formatted according to RFC 2373 "IPv6 Addressing
Architecture," using 8 colon-separated 16-bit hexadecimal values.
One double colon may be used in the address to indicate the
appropriate number of zeros required to fill the undefined fields.
destination-ipv6-address - An IPv6 destination address or network
class. The address must be formatted according to RFC 2373 "IPv6
Addressing Architecture," using 8 colon-separated 16-bit
hexadecimal values. One double colon may be used in the address
– 960 –