Snmp-Server Enable Traps Ethernet Cfm Crosscheck - Edge-Core ES3528MV2 Management Manual

snmp-server enable
traps ethernet cfm
crosscheck
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
This command sets the delay that a device waits for a remote MEP to
◆
come up, and it starts cross-checking the list of statically configure
remote MEPs in the local maintenance domain against the MEPs learned
through CCMs.
The cross-check start delay should be configured to a value greater
◆
than or equal to the continuity check message interval to avoid
generating unnecessary traps.
E
XAMPLE
This example sets the maximum delay before starting the cross-check
process.
Console(config)#ethernet cfm mep crosscheck start-delay 60
Console(config)#
This command enables SNMP traps for CFM continuity check events, in
relation to the cross-check operations between statically configured MEPs
and those learned via continuity check messages (CCMs). Use the no form
to restore disable these traps.
S
YNTAX
[no] snmp-server enable traps ethernet cfm crosscheck [ma-up
| mep-missing | mep-unknown]
ma-up – Sends a trap when all remote MEPs in an MA come up.
mep-missing – Sends a trap if the cross-check timer expires and
no CCMs have been received from a remote MEP configured in the
static list.
mep-unknown – Sends a trap if an unconfigured MEP comes up.
D S
EFAULT ETTING
All continuity checks are enabled.
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
For this trap type to function, cross-checking must be enabled on the
◆
required maintenance associations using the
crosscheck command.
◆ A mep-missing trap is sent if cross-checking is enabled (with the
ethernet cfm mep crosscheck
– 1345 –
C 41
HAPTER
Cross Check Operations
ethernet cfm mep
command), and no CCM is received for a
| CFM Commands