Table 35: Oam Operation State - Edge-Core ES3528MV2 Management Manual

| Basic Administration Protocols
C 14
HAPTER
OAM Configuration
CLI R
EFERENCES
◆ "OAM Commands" on page 1361
P
ARAMETERS
These parameters are displayed:
Port – Port identifier. (Range: 1-28)
◆
Admin Status – Enables or disables OAM functions.
◆
(Default: Disabled)
Operation State – Shows the operational state between the local and
◆
remote OAM devices. This value is always "disabled" if OAM is disabled
on the local interface.

Table 35: OAM Operation State

State
Disabled
Link Fault
Passive Wait
Active Send Local
Send Local And Remote The local OAM entity has discovered the peer but has not yet
Send Local And Remote
OK
OAM Peering Locally
Rejected
OAM Peering Remotely
Rejected
Operational
Non Oper Half Duplex
Mode – Sets the OAM operation mode. (Default: Active)
◆
Active – All OAM functions are enabled.
■
Passive – All OAM functions are enabled, except for OAM discovery,
■
sending variable request OAMPDUs, and sending loopback control
OAMPDUs.
– 552 –
Description
OAM is disabled on this interface via the OAM Admin Status.
The link has detected a fault or the interface is not operational.
This value is returned only by OAM entities in passive mode and
indicates the OAM entity is waiting to see if the peer device is
OAM capable.
This value is used by active mode devices and indicates the
OAM entity is actively trying to discover whether the peer has
OAM capability but has not yet made that determination.
accepted or rejected the configuration of the peer.
OAM peering is allowed by the local device.
The local OAM entity rejects the peering.
The remote OAM entity rejects the peering.
When the local OAM entity learns that both it and the remote
OAM entity have accepted the peering, the state moves to this
state.
This state is returned whenever Ethernet OAM is enabled but
the interface is in half-duplex operation.