| Spanning Tree Commands
C
34
HAPTER
spanning-tree
spanning-disabled
spanning-tree
tc-prop-stop
E
XAMPLE
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree edge-port
Console(config-if)#spanning-tree root-guard
Console(config-if)#
This command disables the spanning tree algorithm for the specified
interface. Use the no form to re-enable the spanning tree algorithm for the
specified interface.
S
YNTAX
[no] spanning-tree spanning-disabled
D
S
EFAULT
ETTING
Enabled
C
M
OMMAND
ODE
Interface Configuration (Ethernet, Port Channel)
E
XAMPLE
This example disables the spanning tree algorithm for port 5.
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree spanning-disabled
Console(config-if)#
This command stops the propagation of topology change notifications
(TCN). Use the no form to allow propagation of TCN messages.
S
YNTAX
[no] spanning-tree tc-prop-stop
D
S
EFAULT
ETTING
Disabled
C
M
OMMAND
ODE
Interface Configuration (Ethernet, Port Channel)
C
U
OMMAND
SAGE
When this command is enabled on an interface, topology change
◆
information originating from the interface will still be propagated.
This command should not be used on an interface which is purposely
◆
configured in a ring topology.
– 1088 –