Fault Generator Operations - Edge-Core ES3528MV2 Management Manual

| CFM Commands
C 41
HAPTER

Fault Generator Operations

Fault Generator Operations
mep fault-notify
alarm-time
When using the command line or web interface, the source MEP used
◆
by to send a loopback message is chosen by the CFM protocol.
However, when using SNMP, the source MEP can be specified by the
user.
E
XAMPLE
This example sends a loopback message to the specified remote MEP.
Console#ethernet cfm loopback dest-mep 1 md voip ma rd
Console#
This command sets the time a defect must exist before a fault alarm is
issued. Use the no form to restore the default setting.
S
YNTAX
mep fault-notify alarm-time alarm-time
no fault-notify alarm-time
alarm-time – The time that one or more defects must be present
before a fault alarm is generated. (Range: 3-10 seconds)
D S
EFAULT ETTING
3 seconds
C M
OMMAND ODE
CFM Domain Configuration
C U
OMMAND SAGE
A fault alarm is issued when the MEP fault notification generator state
machine detects that a time period configured by this command has
passed with one or more defects indicated, and fault alarms are enabled at
or above the priority level set by the
command.
E
XAMPLE
This example set the delay time before generating a fault alarm.
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#mep fault-notify alarm-time 10
Console(config-ether-cfm)#
– 1354 –
mep fault-notify lowest-priority