Control-Vlan - Edge-Core ES3528MV2 Management Manual

| ERPS Commands
C 35
HAPTER

control-vlan

C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
Service Instances within each ring are based on a unique maintenance
◆
association for the specific users, distinguished by the ring name,
maintenance level, maintenance association's name, and assigned
VLAN. Up to 6 ERPS rings can be configured on the switch.
R-APS information is carried in an R-APS PDUs. The last octet of the
◆
MAC address is designated as the Ring ID (01-19-A7-00-00-[Ring ID]).
If use of the default MAC address is disabled with the
command, then the Ring ID configured by the erps domain command
will be used in R-APS PDUs.
E
XAMPLE
Console(config)#erps domain r&d id 1
Console(config-erps)#
This command specifies a dedicated VLAN used for sending and receiving
ERPS protocol messages. Use the no form to remove the Control VLAN.
S
YNTAX
[no] control-vlan vlan-id
vlan-id - VLAN ID (Range: 1-4094)
D S
EFAULT ETTING
None
C M
OMMAND ODE
ERPS Configuration
C U
OMMAND SAGE
Configure one control VLAN for each ERPS ring. First create the VLAN to
◆
be used as the control VLAN (vlan,
the east and west interface as tagged members to this VLAN
(switchport allowed
command to add it to the ring.
The following restrictions are recommended to avoid creating a loop in
◆
the network or other problems which may occur under some situations:
The Control VLAN must not be configured as a Layer 3 interface
■
(with an IP address), a dynamic VLAN (with GVRP enabled), nor as
a private VLAN.
In addition, only ring ports may be added to the Control VLAN. No
■
other ports can be members of this VLAN.
Also, the ring ports of the Control VLAN must be tagged.
■
– 1096 –
page 1132), add the ring ports for
vlan, page 1135), and then use the
no raps-def-mac
control-vlan