erps manual-switch
Table 129: ERPS Request/State Priority (Continued)
Request / State and Status
R-APS (FS)
local SF
a
local clear SF
R-APS (SF)
R-APS (MS)
MS
WTR Expires
WTR Running
WTB Expires
WTB Running
R-APS (NR, RB)
R-APS (NR)
a.
If an Ethernet Ring Node is in the Forced Switch state, local SF is ignored.
Recovery for forced switching under revertive and non-revertive mode
◆
is described under the Command Usage section for the
command.
When a ring is under an FS condition, and the node at which an FS
◆
command was issued is removed or fails, the ring remains in FS state
because the FS command can only be cleared at node where the FS
command was issued. This results in an unrecoverable FS condition.
When performing a maintenance procedure (e.g., replacing, upgrading)
on a ring node (or a ring link), it is recommended that FS commands be
issued at the two adjacent ring nodes instead of directly issuing a FS
command at the ring node under maintenance in order to avoid falling
into the above mentioned unrecoverable situation.
E
XAMPLE
Console#erps forced-switch domain r&d west
Console#
This command blocks the specified ring port, in the absence of a failure or
an
erps forced-switch
command.
S
YNTAX
erps manual-switch [domain ring-name] {east | west}
ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)
east - East ring port.
west - West ring port.
– 1117 –
C
35
HAPTER
Type
Priority
remote
|
local
|
local
|
remote
|
remote
|
local
|
local
|
local
|
local
|
local
|
remote
|
remote
lowest
| ERPS Commands
non-revertive