Edge-Core ES3528MV2 Management Manual page 619

Multicast Router Termination – These messages are sent when a router
◆
stops IP multicast routing functions on an interface. Termination
messages are sent by multicast routers when:
Multicast forwarding is disabled on an interface.
■
An interface is administratively disabled.
■
The router is gracefully shut down.
■
Advertisement and Termination messages are sent to the All-Snoopers
multicast address. Solicitation messages are sent to the All-Routers
multicast address.
MRD messages are flooded to all ports in a VLAN where IGMP
N :
OTE
snooping or routing has been enabled. To ensure that older switches which
do not support MRD can also learn the multicast router port, the switch
floods IGMP general query packets, which do not have a null source
address (0.0.0.0), to all ports in the attached VLAN. IGMP packets with a
null source address are only flooded to all ports in the VLAN if the system is
operating in multicast flooding mode, such as when a new VLAN or new
router port is being established, or an spanning tree topology change has
occurred. Otherwise, this kind of packet is only forwarded to known
multicast routing ports.
P
ARAMETERS
These parameters are displayed:
VLAN – ID of configured VLANs. (Range: 1-4094)
◆
IGMP Snooping Status – When enabled, the switch will monitor
◆
network traffic on the indicated VLAN interface to determine which
hosts want to receive multicast traffic. This is referred to as IGMP
Snooping. (Default: Enabled)
When IGMP snooping is enabled globally (see
interface settings for IGMP snooping take precedence.
When IGMP snooping is disabled globally, snooping can still be
configured per VLAN interface, but the interface settings will not take
effect until snooping is re-enabled globally.
Version Exclusive – Discards any received IGMP messages (except for
◆
multicast protocol packets) which use a version different to that
currently configured by the IGMP Version attribute. (Default: Disabled)
If version exclusive is disabled on a VLAN, then this setting is based on
the global setting configured on the Multicast > IGMP Snooping >
General page. If it is enabled on a VLAN, then this setting takes
precedence over the global setting.
Immediate Leave Status – Immediately deletes a member port of a
◆
multicast service if a leave packet is received at that port and
immediate leave is enabled for the parent VLAN. (Default: Disabled)
– 619 –
| Multicast Filtering
C 17
HAPTER
Layer 2 IGMP (Snooping and Query for IPv4)
page 610), the per VLAN