Configuring Port Supplicant Settings For 802.1X - Edge-Core ES3528MV2 Management Manual

C P
ONFIGURING ORT
S S
UPPLICANT ETTINGS
802.1X
FOR
Click Apply
5.
Figure 215: Configuring Interface Settings for 802.1X Port Authenticator
Use the Security > Port Authentication (Configure Interface – Supplicant)
page to configure 802.1X port settings for supplicant requests issued from
a port to an authenticator on another device. When 802.1X is enabled and
the control mode is set to Force-Authorized (see
Port Authenticator Settings for 802.1X" on page
configure the parameters for the client supplicant process if the client must
be authenticated through another device in the network.
CLI R
EFERENCES
"802.1X Port Authentication" on page 848
◆
C U
OMMAND SAGE
When devices attached to a port must submit requests to another
◆
authenticator on the network, configure the Identity Profile parameters
on the Configure Global page (see
on page 386) which identify this switch as a supplicant, and configure
the supplicant parameters for those ports which must authenticate
clients through the remote authenticator on this configuration page.
When PAE supplicant mode is enabled on a port, it will not respond to
dot1x messages meant for an authenticator.
– 391 –
| Security Measures
C 13
HAPTER
Configuring 802.1X Port Authentication
"Configuring
387), you need to
"Configuring 802.1X Global Settings"