Table 162: Multicast Vlan Registration For Ipv4 Commands; Mvr For Ipv4 - Edge-Core ES3528MV2 Management Manual

| Multicast Filtering Commands
C 39
HAPTER

MVR for IPv4

MVR IP 4
FOR V
This section describes commands used to configure Multicast VLAN
Registration for IPv4 (MVR). A single network-wide VLAN can be used to
transmit multicast traffic (such as television channels) across a service
provider's network. Any multicast traffic entering an MVR VLAN is sent to
all subscribers. This can significantly reduce to processing overhead
required to dynamically monitor and establish the distribution tree for a
normal multicast VLAN. Also note that MVR maintains the user isolation
and data security provided by VLAN segregation by passing only multicast
traffic into other VLANs to which the subscribers belong.

Table 162: Multicast VLAN Registration for IPv4 Commands

Command Function
mvr Globally enables MVR
mvr associated-profile Binds the MVR group addresses specified in a profile to
an MVR domain
mvr domain Enables MVR for a specific domain
mvr priority Assigns a priority to all multicast traffic in the MVR
VLAN
mvr profile Maps a range of MVR group addresses to a profile
mvr proxy-query-interval Configures the interval at which the receiver port
sends out general queries.
mvr proxy-switching Enables MVR proxy switching, where the source port
acts as a host, and the receiver port acts as an MVR
router with querier service enabled
mvr robustness-value Configures the expected packet loss, and thereby the
number of times to generate report and group-specific
queries
mvr source-port-mode Configures the switch to only forward multicast
dynamic streams which the source port has dynamically joined
mvr upstream-source-ip Configures the source IP address assigned to all
control packets sent upstream
mvr vlan Specifies the VLAN through which MVR multicast data
is received
mvr immediate-leave Enables immediate leave capability
mvr type Configures an interface as an MVR receiver or source
port
mvr vlan group Statically binds a multicast group to a port
clear mrv groups dynamic Clears multicast group information dynamically
learned through MVR
clear mrv statistics Clears MRV statistics
show mvr Shows information about MVR domain settings,
including MVR operational status, the multicast VLAN,
the current number of group addresses, and the
upstream source IP address
show mvr Shows the profiles bound the specified domain
associated-profile
– 1258 –
Mode
GC
GC
GC
GC
GC
GC
GC
GC
GC
GC
GC
IC
IC
IC
PE
PE
PE
PE