| Basic Administration Protocols
C
14
HAPTER
Link Layer Discovery Protocol
C
ONFIGURING
LLDP I
NTERFACE
C
-A
IVIC
DDRESS
W
I
EB
NTERFACE
To configure LLDP interface attributes:
Click Administration, LLDP.
1.
Select Configure Interface from the Step list.
2.
Set the LLDP transmit/receive mode, specify whether or not to send
3.
SNMP trap messages, and select the information to advertise in LLDP
messages.
Click Apply.
4.
Figure 237: Configuring LLDP Interface Attributes
Use the Administration > LLDP (Configure Interface – Add CA-Type) page
to specify the physical location of the device attached to an interface.
CLI R
EFERENCES
"lldp med-location civic-addr" on page 1308
◆
C
U
OMMAND
SAGE
Use the Civic Address type (CA-Type) to advertise the physical location
◆
of the device attached to an interface, including items such as the city,
street number, building and room information. The address location is
specified as a type and value pair, with the civic address type defined in
RFC 4776. The following table describes some of the CA type numbers
and provides examples.
– 430 –