Table 104: Mac Acl Commands; Mac Acls - Edge-Core ES3528MV2 Management Manual

| Access Control Lists
C 26
HAPTER

MAC ACLs

MAC ACL
S
access-list mac
The commands in this section configure ACLs based on hardware
addresses, packet format, and Ethernet type. The ACLs can further specify
optional IP and IPv6 addresses including protocol type and upper layer
ports. To configure MAC ACLs, first create an access list containing the
required permit or deny rules, and then bind the access list to one or more
ports.

Table 104: MAC ACL Commands

Command Function
access-list mac Creates a MAC ACL and enters configuration mode
permit, deny Filters packets matching a specified source and
destination address, packet format, and Ethernet type.
They can be further specified using optional IP and
IPv6 addresses including protocol type and upper layer
ports.
mac access-group Binds a MAC ACL to a port
show mac access-group Shows port assignments for MAC ACLs
show mac access-list Displays the rules for configured MAC ACLs
This command adds a MAC access list and enters MAC ACL configuration
mode. Use the no form to remove the specified ACL.
S
YNTAX
[no] access-list mac acl-name
acl-name – Name of the ACL. (Maximum length: 16 characters, no
spaces or other special characters)
D S
EFAULT ETTING
None
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
When you create a new ACL or enter configuration mode for an existing
◆
ACL, use the permit or deny command to add new rules to the bottom
of the list.
◆ To remove a rule, use the no permit or no deny command followed by
the exact text of a previously configured rule.
An ACL can contain up to 64 rules.
◆
– 964 –
Mode
GC
MAC-ACL
IC
PE
PE