Mvr Vlan Group - Edge-Core ES3528MV2 Management Manual

| Multicast Filtering Commands
C 39
HAPTER
MVR for IPv4

mvr vlan group

Receiver ports can belong to different VLANs, but should not normally
◆
be configured as a member of the MVR VLAN. IGMP snooping can also
be used to allow a receiver port to dynamically join or leave multicast
groups not sourced through the MVR VLAN. Also, note that VLAN
membership for MVR receiver ports cannot be set to access mode (see
the switchport mode
One or more interfaces may be configured as MVR source ports. A
◆
source port is able to both receive and send data for multicast groups
which it has joined through the MVR protocol or which have been
assigned through the
Only IGMP version 2 or 3 hosts can issue multicast join or leave
◆
messages. If MVR must be configured for an IGMP version 1 host, the
multicast groups must be statically assigned using the
command.
E
XAMPLE
The following configures one source port and several receiver ports on the
switch.
Console(config)#interface ethernet 1/5
Console(config-if)#mvr domain 1 type source
Console(config-if)#exit
Console(config)#interface ethernet 1/6
Console(config-if)#mvr domain 1 type receiver
Console(config-if)#exit
Console(config)#interface ethernet 1/7
Console(config-if)#mvr domain 1 type receiver
Console(config-if)#
This command statically binds a multicast group to a port which will receive
long-term multicast streams associated with a stable set of hosts. Use the
no form to restore the default settings.
S
YNTAX
[no] mvr [domain domain-id] vlan vlan-id group ip-address
domain-id - An independent multicast domain. (Range: 1-5)
vlan-id - Receiver VLAN to which the specified multicast traffic is
flooded. (Range: 1-4094)
group - Defines a multicast service sent to the selected port.
ip-address - Statically configures an interface to receive multicast
traffic from the IPv4 address specified for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
D S
EFAULT ETTING
No receiver port is a member of any configured multicast group.
– 1268 –
command).
mvr vlan group command.
mvr vlan group