Displaying Dhcp Snooping Binding Information - Edge-Core ES3528MV2 Management Manual

| Security Measures
C 13
HAPTER
DHCP Snooping
D DHCP
ISPLAYING
S B
NOOPING INDING
I
NFORMATION
Figure 230: Configuring the Port Mode for DHCP Snooping
Use the IP Service > DHCP > Snooping (Show Information) page to display
entries in the binding table.
CLI R
EFERENCES
"show ip dhcp snooping binding" on page 910
◆
P
ARAMETERS
These parameters are displayed:
◆ MAC Address – Physical address associated with the entry.
IP Address – IP address corresponding to the client.
◆
Lease Time – The time for which this IP address is leased to the client.
◆
Type – Entry types include:
◆
DHCP-Snooping – Dynamically snooped.
■
VLAN – VLAN to which this entry is bound.
◆
Interface – Port or trunk to which this entry is bound.
◆
Store – Writes all dynamically learned snooping entries to flash
◆
memory. This function can be used to store the currently learned
dynamic DHCP snooping entries to flash memory. These entries will be
restored to the snooping table when the switch is reset. However, note
that the lease time shown for a dynamic entry that has been restored
from flash memory will no longer be valid.
Clear – Removes all dynamically learned snooping entries from flash
◆
memory.
W I
EB NTERFACE
To display the binding table for DHCP Snooping:
Click IP Service, DHCP, Snooping.
1.
Select Show Information from the Step list.
2.
– 416 –