NEC SL1100 Features And Specifications Manual page 853

ISSUE 2.0
To program a key, press Speaker key, dial 751 (for 2-digit codes) or 752 (for 3-digit codes), press the key
Use this key... For this feature...
Code: 44
Operation: Place
or answer call +
Press key
Code: 45
Operation: Place
or answer call +
Press key
Code: 46 Department Calling
Operation: Press
key
Code: 47 + dest. Reverse Voice Over
ext.
Operation: Press
and hold key
Code: 48 Voice Over
Operation: Hear
Off-Hook Signal-
ing tones + Press
key
Code: 49 + ext or Call Redirect
voice mail number
Operation: Press
key
Code: 50 Account Codes
Operation: Press
key
Code: 55 Name Storing
Operation: Do not
Lift the handset +
Press key + Enter
extension number
+ Enter name +
Press Hold
Code: 83 + 0~4 Voice Mail
Operation: Press
key
Code: 77 + exten-
sion or Message
Center number
Operation: Press
key
Code: 78 + Con-
versation Record
Operation: Press
key
Code: 79 + ext or Voice Mail
pilot number
Operation: Press
key
Code: 80 + ext Tandem Ringing
number
Operation: Press
key
Code: 81 + trunk Automatic Transfer
line 001 ~ 76 to Transfer
Operation: Press
key
Features and Specifications Manual
and enter the code (e.g., 48 for Voice Over).
When you ...
Hold Put a call on Sys-
tem Hold (if Hold
key is reassigned).
Put a call on Exclu-
sive Hold.
Log in or log out of
your Department
Calling Group.
Initiate Reverse
Voice Over.
Initiate or respond
to Voice Over.
Redirect an incom-
ing call to an exten-
sion or voice mail.
Enter Account Co-
des.
Change the name
displayed on your
display telephone.
Use Voice Mail
Service.
Call Voice Mail or
leave a message.
Use Conversation
Record.
Use Automated At-
tendant.
Set up Tandem
Ringing
Set up Automatic
Transfer to Transfer
Key Lamp Status Also see Srvc
None
None
On when removed, Off
when installed
Full BLF red
On red when respond-
ing Hold Flash red
when listening
On red when activated
Flashes when in DND/
Call Forward
None
None
Flashes slowly when
monitoring
Flashes green on your
key for your messages
or flashes red for the
Message Center
Flashes red when re-
cording
On when setup for All
calls.
Slow flash when setup
for Busy/No answer
calls.
On for Master Side. not assigned
Slow flash for Slave
Side.
Slow Flash when set.
SL1100
Note
Code
-
-
650
-
690
-
* or ##
700
-
* 8 or 8
-
-
833
2-23