NEC SL1100 Features And Specifications Manual page 705

Hide thumbs Also See for SL1100:
Table of Contents

Advertisement

ISSUE 2.0
Program Num-
ber
*1
InMail Port
47-01-17
This command enables or disables the ability for the system to
send the caller ID information to the Voice Mail.
This command is for ALL trunk types (analog, digital, and IP).
DTMF Relay Mode
*1
84-12-31
This program assigns the way the system handles DTMF
across the SL Net network.
When Centralized VM is required this program must be set to
(1) RFC2833.
SL Net Basic Features
Refer to the SL1100 Feature and Specifications Manual for a complete description and programming
information for the following features. The information detailed here applies only to the feature when
used in a Networked system.
ICM calling
An extension user can make an intercom call to a networked system if the networked extensions are
defined with the Network Access Code (PRG 11-01, Dial Type = 8). A user can change the signaling
type for the intercom call they place to either a voice announce or ringing call to an extension in a
networked system.
Operation
To place an Intercom call:
1.
At a Multiline Terminal, press Speaker key or Lift the Handset.
- OR -
At a Single Line telephone, lift the handset.
2.
Dial the extension number (or 0 for the operator).
Your call may voice-announce or ring the called extension. Dial 1 on the key pad to toggle back and
forth between ring and voice-announce.
Voice Mail, Centralized
Networking will support the use of a single InMail for the entire network. A user may call into the voice
mail from anywhere in the network and perform functions as if the voice mail were located on their
premises.
Operation
To place a Voice Mail call:
1.
At a Multiline Terminal, press Speaker key or Lift the Handset.
- OR-
At a Single Line telephone, lift the handset.
2.
Dial the pilot number of the Voice Mail (PRG 45-01-07).
Features and Specifications Manual
Program Name
SL1100
Default
1 ~ 69 (Can only use the port numbers
provided in the description section)
(default)
not assigned
0 = Disable
1 = RFC 2833
2 = VoIPU
(default)
2
S
1-693

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents