NEC SL1100 Features And Specifications Manual page 476

SL1100
DID Line Service
Program
Number
10-03-20 ISDN Protocol Selection
Assign the protocol that is to be used for the ISDN service.
The setting in the SL1100 MUST match the setting that the Telco has
configured.
22-02-01 * Incoming Call trunk Setup
Assign all PRI trunks as an incoming type of DID (setting data 3).
This program is per trunk and per day/night mode, which there are 8
day/night modes. It is recommended that all 8 day/night modes be set
I
as DID.
14-05-01 Trunk Group Setup
Assign all PRI trunks, including the D-Channel, to a valid trunk group.
Do not assign any used PRI trunks in trunk group 0.
22-09-01 Expected number of Digits
Enter the number of digits, per the trunk group assigned in PRG
14-05, that the Telco will be sending to the SL1100 as DID's.
The SL1100 will analyze the digits received from the Telco starting
from the last digits working towards the first digits.
Example:
If the SL1100 was set to receive 4 digits and the Telco sent 10 digits
(214-555-1000) the SL1100 would route off of the last 4 digits re-
ceived (1000).
22-13-01 DID Trunk Group to Translation Table Assignment
Per day/night mode a translation area must be assigned to the trunk
group. This will allow for DID's to route to different places in day/night
modes.
22-10-01 DID Translation Table Setup
Assign the DID translation tables (in PRG 22-11) that are going to be
used to route the DID digits.
22-11-01 * Received Number
Enter the digits received from the Telco that are going to be transla-
ted.
The amount of digits entered should be equal to the setting assigned
in PRG 22-09-01.
22-11-02 * Target Number
Enter the destination number to which the DID is to be sent.
20-09-02 * Caller ID Display
Per class of service this allows or denies the stations from receiving
the caller ID name/number that the Telco is sending in.
1-464
Program Name/Description
ISSUE 2.0
Assigned Data
0 = Standard
3 = DMS (A211)
4 = 5ESS
5 = DMS (A233)
6 = 4ESS
7 = NI2
(default = 7)
0 = Normal
1 = VRS
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie Line
6 = Delay VRS
7 = ANI/DNIS
8 = DID (DDI) Mode Switching
(default = 0)
0 ~ 25
(default = 1)
1 ~ 8
(default = 4)
0 = No Routing
1 ~ 20 = Table Area (assigned in
PRG 22-10)
(default = 1)
0 = No Routing
1 ~ 800 = Tables 1 ~ 800 (assigned
in PRG 22-11)
(Refer to the programming manual for
the default values of all tables.)
Maximum of 8 digits (0 ~ 9, * , #)
(default = Not Assigned)
Maximum of 8 digits (0 ~ 9, * , #, @)
(default = Not Assigned)
0 = OFF (Caller ID NOT displayed.)
1 = ON (Caller ID IS displayed.)
(default = 0)
ISDN Compatibility