NEC SL1100 Features And Specifications Manual page 475

ISSUE 2.0
• Calling Party Number (CPN) presentation from station is available for virtual extensions.
• The trunk setting (PRG 20-19-09) for sending the caller name on outgoing ISDN calls takes priority
over the same setting for the station (PRG 15-01-01).
• When programmed, Calling Party Name will be sent on calls that originate from a station (MLT, SLT,
or IP Multiline) or an incoming trunk (Analog or ISDN).
• Calling Party Name supports up to 12 ASCII characters.
• When a call originates from a virtual extension, the Calling Party Name for the virtual extension is
sent. It does not follow the setting in PRG 15-18-02.
• Calling Party Name is dependant upon the carrier. The network carrier must allow the SL1100 to
edit the Calling Party Name information.
• SL1100 does not support ISDN sub-addressing.
Default Settings
None
System Availability
Terminals
Not Applicable
Required Component(s)
To provide ISDN-PRI trunk connection:
• 1PRIU-C1
Related Features
Central Office Calls, Answering
Central Office Calls, Placing
Direct Inward Dialing (DID)
Direct Inward Line (DIL)
Forced Trunk Disconnect
Station Message Detail Recording
Transfer
Guide to Feature Programming
The programs listed below indicate the most commonly used programs required for this feature. The
programs are listed in the order that the installer should follow. Refer to the PCPro wizards for further
detailed programming.
• When a * is listed next to the Program Number it indicates a program that MUST be set (from a
default state) for this feature to be enabled.
Features and Specifications Manual
SL1100
I
1-463