Powering Down - Christie J Series User Manual

6. Adjust cross-hair pattern II, by adjusting the appropriate capscrew, see
until the cross-hair image is in focus with minimal flare.
7. Adjust cross-hair pattern III, by adjusting the appropriate capscrew, see
Adjust until the cross-hair image is in focus with minimal flare.
8. Repeat step 5, 6, and 7 as required until all 3 cross-hair patterns are in equal sharp focus. If the boresight is
acceptable, see step 11. If the boresight does not appear to be converging to an acceptable level of image
quality or if the lens will not focus over the correct range of throw distances, then the boresight requires
coarse adjustment, see step 9.
9. The original factory boresight can be recovered approximately by positioning the 3 setscrews, see
2-4 Screw Locations. Position the setscrews flush with the front face of the lens mount plate and in contact
with the inner lens mount plate. This may require adjusting both setscrews and capscrews.
10. If further action is required. Repeat #2.
11. Lock the setscrews so they do not shift, and re-check the boresight quality.

2.4.10Powering Down

The projector can be powered down by using one of
the following methods:
Remote Keypad/Built-In Keypad
• Press and hold P
-OR-
• Press P
OWER
-OR-
• Press P
OWER
NOTES: 1) For Step 2 and 3, if the second key is not pressed immediately, a confirmation window will appear.
The second key press must be pressed within 1 second of the window appearing. 2) After powering down, the
Status LEDs cycle and the LCD displays the message "Cooling Down", until cool down is complete.
Web User Interface (UI)
1. From the Main Tab, Select Power > OFF.
NOTE: A window will display for confirmation on powering down.
2. Select Yes.
J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)
OWER
twice
once, then press the D
OWN
key.
Section 2: Installation and Setup
Figure 2-4 Screw Locations.
Figure 2-4 Screw Locations.
Adjust
Figure
2-23