Christie J Series User Manual page 124

Section 4: Web User Interface
Add a Scheduled Event
1. Click Add to open the RTE Wizard.
2. Select the Scheduled Event tab.
NOTE: The scheduled tab is always selected by default on add.
3. Select the frequency option for the event by selecting either Once, Daily, Weekly, or Monthly.
NOTE: End Date is enabled when Daily, Weekly or Monthly repeat options are selected.
4. Click within the Start Time field to open a calendar pop-up window.
5. Navigate to and choose a desired date. The selected date will populate the Start Time field.
6. In the field below the Start Time field, enter a start time in the format "hr:min:sec". The default is the
current time.
7. Click Sync to set the computer and projector time to be the same; otherwise, the event will run based on
the projector time. NOTE: Syncing the projector time to be that of your system time.
8. Enter a description of the scheduled event in the Description field. NOTE: Maximum of 100 characters.
9. Enter a serial command or a sequence of serial commands, with which you wish the projector to perform in
the Command String box.
• If a GPIO command string is needed, click the GPIO Output Helper button for instructions on how to
create the command structure.
NOTES: 1) The Output field contains 7 blocks which refer to the 7 I/O pins on the GPIO connector. Pin
1 = +12V and Pin 5 = Ground. These are not included. 2) Clicking a block toggles between H, L, and X.
3) If the Pulse check box is selected, those I/O Pins defined will pulse high or low. See
gration - GPIO Connector
• Click the Help button for a description of special RTE commands available for adding loops and delays
to the command sequence.
4-10
for detailed information. 4) Serial Representation box is read only.
2.5.9 System Inte-
J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)