Online Help; The Global Icon; How To Use Slide Bars And Other Controls - Christie J Series User Manual

Section 3: Operation
When finished with a function menu:
• Press E
XIT
to return to the previous screen.
-OR-
• Press M
ENU
to leave the menu system and return to the presentation.
NOTES: 1) If there is no signal present, all source-dependent adjustments are disabled. 2) After 15 minutes of
inactivity, the projector leaves the menu system and returns to the presentation. 3) The Status menu is read-
only.

3.2.2 Online Help

Press H to display summary information about the current menu or highlighted option. Press H
ELP
exit.
1. Size & Position
2.
Image Settings
3.
Channel Setup
4. Configuration
5. Lamp
6.
Status
7.
Input Switching & PIP
8. Test Pattern
9.
Language

3.2.3 The Global Icon

Menu options that include this icon apply universally. Menu options without this icon apply to the
selected channel only.

3.2.4 How to Use Slide Bars and Other Controls

Most of the function menus allow you to change settings by using slide bars, check boxes, and pull-down lists.
• Enter the menu option number corresponding to the setting you wish to change.
For example, press M
• Move the highlight to the option desired and press E
• Move the highlight to the option desired and press L
• You can bypass the menus entirely and use a single key to immediately access an adjustment during your
presentation (applies only to options having their own key, such as Contrast, Brightness, Gamma, etc.).
• For "blind" access, hide the entire menu system (see OSD key, above) and access using the proper sequence
of key presses.
Slide Bars In Menus: The current value for a given parameter,
such as size or vertical stretch, appears to the left of its slide bar
icon (adjustment window). This number often expresses a
percentage, or it may have units associated with it (such as
pixels), depending on the specific option. Press L
down; both the number and the length of the bar change accordingly. Hold for continuous adjustment. Or press
E to activate a slide bar text box for specific number entry via the keypad and then press E
NTER
(or press E
XIT
to cancel).
3-10
Main Menu
Help
Off
English
1, 3 to select "Vertical Stretch" in the Size and Position menu.
ENU
Use this menu to adjust settings affecting current image
size and position, such as horizontal and vertical
placement, blanking, resizing, and others.
NTER
.
/R A
EFT IGHT RROW
1.
/R A K
EFT IGHT RROW EY
ELP
Help
K
EY
to adjust immediately.
White Uniformity
Left Side 35.6
to gradually adjust the setting up or
NTER
J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)
again to
to save