Christie J Series User Manual page 73

To Edit A Channel: Press M
Channel Setup menu, press 3 or move the highlight to the Channel Setup option and press E
Channel Setup menu will appear.
1. To edit parameters shown in the Channel Setup menu, select the relevant channel and press E
Channel Edit menu will appear similar to the sample shown below.
2. If desired, review and/or edit the following channel setups in the Channel Edit menu:
• Name: An alphanumeric label can be defined and/or changed here. Channel names can be up to 12 charac-
ters in length. The default name is the horizontal and vertical sync frequencies.
• Channel: A two-digit channel number can be changed here.
NOTES: 1) If you enter a channel number that already exists, a dialog message appears indicating that
this number is already in use; assign a different channel number. 2) You can define up to 99 channels.
• Slot: 1-4, corresponding to which slot in the projector's input panel the source is connected:
• Input: 1-6, corresponding to which input on the selected slot the source is connected to.
• In Menu: If checked (default, except for automatically defined channels with unchanged parameters), this
defined channel will then appear in the list available when C
channel must be accessed via C
NOTE: On-screen display of the channel list is an option that must be set in the Menu Preferences menu.
• Auto Select: If checked, (default), the projector can automatically locate this channel when an incoming
input signal matches. If not checked, the projector can locate the selected channel only when it is directly
selected via C
• Locked: If checked, all of the image settings for this channel are locked. If unchecked (default), all avail-
able image settings can be adjusted as desired. You cannot use Auto Setup with a locked channel.
• Previous Channel: Select this option to see or change Channel Edit settings for the previous channel in
the Channel Setup list.
• Next Channel: Select this option to see or change Channel Edit settings for the next channel in the
Channel Setup list.
J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)
ENU
from the presentation level to display the Main menu. To display the
Card Type
H-Frequency
V-Frequency
Interlaced
Sync Source
1. Name
2. Channel
3.
Slot
4. Input
5. In Menu
6.
Auto Select
7. Locked
8. Previous Channel
9.
Next Channel
HANNEL
HANNEL
on the keypad; a change in input signal will not result in a channel change.
Channel Edit: 01
Video Decoder Input Card
15.73 kHz-
59.94 Hz-
Yes
S-Video
15.73kHz- i59.94Hz-
1
1
1
HANNEL
on the keypad or via the Auto Source function.
Section 3: Operation
NTER
key is pressed. If unchecked, the
. The
NTER
. The
3-17