Christie J Series User Manual page 110

Section 3: Operation
To access the Service menu (password-protected) return to the factory-set color primaries. Select the Reset to
Factory Defaults option in the Color Primaries submenu. Then repeat the calibration process describe above
and continue with matching of colors.
3.13.3Color Adjustment Procedure
Once the Color Primary Settings are calibrated for the site (see above), use the Color Adjustments by X,Y or
Color Saturation menu to further refine each projector's fundamental colors so that the hue and intensity of
each color appears the same from one display to another. Once matched, you will have created a single new
shared range of colors or "color gamut" that all of your projectors can produce. This palette—named User 1, 2,
3 or 4—can be applied or disabled for a source at any time throughout a bank of adjacent displays, simplifying
both the setup and maintenance of a "seamless" wall.
1. Set up and optimize all projector settings. You can ignore color temperature, since you will be redefining
color performance in this procedure, but do optimize each projector in every other aspect. Closely align all
screen edges.
2. Assign projector numbers to make communications easier. Use desired keypad.
3. Use the same lamp mode for all projectors, and do the following:
• Set Select Color Adjustment to Max Drives
• Display a full white test pattern
• Adjust lamp power and Optical Aperture until adjacent white fields appear the same brightness.
• Display the Color Adjustments by X,Y menus for all projectors. Each menu shows the x/y coordinates
defining the "Max Drives" color gamut for this projector.
NOTE: The values shown in one (any) of the displays. Use the "Copy From" function to copy them into
a "User" gamut in one projector.
1. Select Color Adjustment
2. Color Temperature
3. Red X
4. Red Y
5.
Green X
6. Green Y
7. Blue X
8. Blue Y
9. White X
10. White Y
11. Yellow Notch Filter
12. Auto Color Enable
13. Color Enable
14. Copy From
3-54
Color Adjustments by X,Y
Max Drives 1.
6521 2.
0.655 3.
0.341 4.
0.332 5.
0.575 6.
0.144 7.
0.093 8.
0.320 9.
0.330 10.
11.
12.
Red 13.
Max Drives 14.
Color Adjustments by X,Y
Select Color Adjustment Max Drives
Color Temperature 6521
Red X 0.640
Red Y 0.350
0.329
Green X
Green Y 0.560
Blue X 0.129
Blue Y 0.100
White X 0.374
White Y 0.367
Yellow Notch Filter
Auto Color Enable
Color Enable Red
Copy From Max Drives
Color Adjustments by X,Y
1. Select Color Adjustment Max Drives
2. Color Temperature 6521
3. Red X 0.626
4. Red Y 0.350
5. 0.331
Green X
6. Green Y 0.528
7. Blue X 0.133
8. Blue Y 0.106
9. White X 0.323
10. White Y 0.359
11. Yellow Notch Filter
12. Auto Color Enable
13. Color Enable Red
14. Copy From Max Drives
J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)