Lamp And Filter Replacement; Lamp Replacement Procedure - Christie J Series User Manual

5 Maintenance
Installers, service trained operators and all other users must maintain a safe operating environment at all times.
Read through this section in its entirety and understand all warnings and precautions before attempting to
operate this projector.
5.1

Lamp and Filter Replacement

Do not operate the lamp for more than the warranty limit; risk of the lamp shattering increases as a result of
changes in the quartz glass that occur with use. Operation beyond the lamp warranty limit also significantly
reduces brightness output.

5.1.1 Lamp Replacement Procedure

For this procedure you will need the appropriate Lamp and Filter Kit manufactured by Christie Digital
Systems. See Table
Table 5.1
PROJECTOR PART
NUMBER
Roadster S+14K-J
Mirage S+14K-J
Roadster HD14K-J
Mirage HD14K-J
Mirage WU14K-J
Matrix WU14K-J
J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)
Wait approximately 5 minutes after powering down the projector to allow the
lamp to cool sufficiently before removing.
Never attempt to remove the lamp housing directly after use. The lamp is
under great pressure when hot and may explode, causing personal injury and/
or property damage.
Use only lamps supplied by Christie.
High leakage current. Earth connection essential before connecting supply.
A Christie accredited service technician must perform lamp replacement.
Cool the lamp completely, then lift the lamp by the handle only.
Do not touch the glass window of the lamp. Fingerprints left on the surface
can lead to an intense accumulation of heat called a 'hot spot', which could
potentially result in lamp failure. It is recommended you wear a face shield
when working with the lamp.
5.1.
PROJECTOR
MODEL
132-010113-XX
132-010124-XX
132-011114-XX
132-011125-XX
132-012126-XX
132-012137-XX
LAMP TYPE
2.0 kW
LAMP/FILTER KIT
REQUIRED
003-120135-XX
5-1