Configuration - Adjust System Parameters And Advanced Controls; Language; Output Options Card - Submenu - Christie J Series User Manual

3.9

Configuration - Adjust System Parameters and Advanced Controls

Use the Configuration menu to define general
operating parameters and communications with
other projectors and equipment, and to access other
advanced processing and image adjustments
affecting overall performance. The Configuration
menu provides access to diagnostics, calibration
tools and the Service submenu (password-
protected).
The first six options in the Configuration menu are
explained below:

3.9.1 Language

Choose the available language to use in the projector menus. The change will take effect immediately.

3.9.2 Output Options Card - Submenu

• Screen Image Orientation: Select the on screen image orientation from Front, Rear, Front Inverted, and
Rear Inverted.
• Frame Locking: Select how the projector controls the output frame timing based on the input signal. When
set to Framelock, output image frames are locked to the input if possible. When Locked, the output is
always locked to the primary input, never the PIP/Secondary image. Free Run sets the output to close to
60Hz for all sources.
NOTE: When switching to a new input with frame locking enabled, the image will appear black for a short
duration while the system locks onto the new input.
• Set Frame Delay: This control delays the output signal timing relative to the input signal timing by a
fraction of a frame, and up to several frames. The minimum latency can vary based on the amount of scaling
applied to the image. When using keystone or warping, an additional latency is required, depending on the
amount of warp. The control is only available when the input signal is frame locked. In free run mode, or in
cases where the signal cannot be frame locked, the minimum latency defined by the scaling and keystone/
warp is applied to the signal.
• Actual Frame Delay: Dynamically calculated by the software as the achievable range being smaller than
the set range. The image parameters include, image shift, scaling, warp/keystone applied and format. The
menu displays both the user selected value and the actual frame delay value. When setting up tiling of
projectors, all projectors in the tile should be set to the worst case, which is the projector with the highest
minimum for the setup.
• Free Run Frequency: This control sets the output video vertical frequency.
• Fade To Black Time: This control sets the amount of time (in seconds) that it takes to fade the image to/
from black.
NOTE: The OSD only allows the fade time to be set. To initiate a Fade to Black, the Christie Serial
command should be used.
J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)
Configuration
1. Language
2.
Output Options
3. Lens Settings
4. Power Management
5.
Date & Time
6. Menu Preferences
7. Communications
8. Geometry & Color
9.
Diagnostics & Calibration
10. Service
11. Option Card Settings
12.
Dynamic Iris
Section 3: Operation
English
3-31