Christie J Series User Manual page 108

Section 3: Operation
• Pip Window Size: Sets the width of the PIP window in pixels. The active portion of the input signal, as
determined by blanking controls, will be scaled to fit into the PIP window. The height of the PIP window will
be set to maintain the aspect ratio of the image being captured, as determined by the Vertical Stretch control.
• Pip H-position: Sets the center position of the Picture-In-Picture window on the screen.
• Pip V-position: Sets the center position of the Picture-In-Picture window on the screen.
• Pip Border Width: Specify how thick the Picture-In-Picture border should be. Setting the control to zero
disables the border. The thickness of the border is proportional to the size of the PIP image.
• Pip Border Color: Choose the color of the optional border around the Picture-In-Picture image.
3.11.6PIP Size and Position - Submenu
Most controls in the PIP Size and Position menu adjust the PIP (secondary) image in the same fashion as their
counterparts in the main Size and Position menu.
• Position Presets: Set the location of the PIP (secondary) image in the display.
3.11.7PIP Image Settings - Submenu
The controls adjust the PIP (secondary) image in the same fashion as their counter parts in the main Image
Settings menu.
NOTE: See
3.6 Image Settings Menu
3.11.8Fade Time
Sets the amount of time (in seconds) it takes to fade between images on a source switch and fades in the PIP
image.
3.11.9Frame Locking
When the selection is set to Frame Lock, output image frames are locked to the input. When locked, the
output is always locked to the primary input, never the secondary image. Select Free Run and this will set the
output to close at 60Hz for all sources.
NOTE: Seamless switching is only available when free run is selected. When switching to a new input with
frame locking enabled, the image will be black for the short period while the system locks onto the new input.
3.11.10Auto Input Searching
When enabled, the system will continually search for the next valid signal when no signal is present or when
loss of sync occurs on the current user selected input. In the case of multiple signals to choose from, the order
is based on slot, followed by inputs on that slot.
3.11.11HDMI Output Loop Source
Configure the HDMI output options.
Select Direct Loop to directly pass-through the HDMI input signals (from the same Twin HDMI Input Card).
The Input1 signal is looped to Output1 and the Input2 is looped to Output2.
Select Main/Secondary Loop to loop the Main and secondary video to the outputs (regardless of which card
these signal originate from). The Main video signal is looped to Output1 and the Secondary video signal is
looped to Output2.
Select Disable to shut off the HDMI outputs completely.
3-52
for details of Contrast to Advanced Image Settings.
J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)