Christie J Series User Manual page 35

1. Position the projectors.
• Place each projector to be stacked on a secure
table or cart.
• Place 1 projector on its side to access its adjust-
able feet, and stacking legs.
• Orient the other projector in either upright or
inverted position as required (remember, each
projector in a stack must be in the same orienta-
tion).
2. Fully retract each foot (4) as far as possible by
turning them clockwise.
• If upright, retract the feet on top projector.
• If inverted, retract the feet on bottom projector
3. Extend the stacking legs (3) by turning them so that
at least 1 inch of thread is visible on each. This clearance
accommodates the up-or-down movement for aligning the
images from the stacked projectors. Ensure that you extend all
3 legs equally so they are level.
• If upright, extend legs on top projector (shown)
• If inverted, extend legs on bottom projector
IMPORTANT! Extend stacking legs equally, by at least 1 inch.
4. On the rear stacking legs, loosen the nuts so the
legs have some lateral movement for easier
alignment with the stacking mounts on the
other projector.
• If upright, release on top projector
• If inverted, release on bottom projector
J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)
Section 2: Installation and Setup
2-17