Mounting; Adjusting Projector Height/Tilt - Christie J Series User Manual

Section 2: Installation and Setup
• If center lines are parallel, but others are not, turn the front stacking mount wheel to bring the center lines
into alignment.
6. Align the edges of the grid with center lines aligned:
a. Adjust zoom (top projector) to align the edges of its image with the other image.
b. Adjust focus. When aligned, all lines from the combined red/green grids will be yellow.
7. Secure all stacking wheels and leg nuts
• Turn all 3 stacking wheels until they are firmly secure against the rest of
the stacking mount.
• Secure both 2 rear leg nuts against the bottom of the projector.
8. Repeat Steps 1 to 7 if stacking a third projector.

2.4.6 Mounting

There are several methods for mounting the projector. Depending on your chosen
installation, one method may be more suitable than another. In typical front and rear screen installations the
projector can be mounted to a secure and level surface, such as a table or cart. Carts are useful when the
projector has to be moved during a presentation or from site to site. It is recommended you lock the wheels on
a cart, when it is in position, to prevent someone from accidentally moving it during a presentation.
Ceiling Mount
The projector can be inverted and suspended from the ceiling using a specially designed ceiling mount 104-
104001-XX. This mounting is recommended for fixed installations and for those that want the projector out of
plain view or have limited amount of space for the projector and audience.

2.4.7 Adjusting Projector Height/Tilt

Adjusting Height
You can modify the height of the projector to remedy a slightly
uneven mounting surface by adjusting the four feet threaded into
the bottom chassis. Turn each foot clock-wise or counter-
clockwise until the projector is level on all sides.
Tilting the Projector
In the landscape orientation, the projector can be rotated to any
angle (roll/pitch) and tilted to any vertical angle (i.e., you can tilt
the face of the projector up or down as much as desired for your
installation). For maximum lamp life, side-to-side tilt must not
exceed 15 degrees. Tilt angles including portrait mode are allowed
as shown.
2-20
Critical Safety Procedure.
Use only the Christie approved ceiling mount kit designed for your projector.
See the installation instructions and safety guidelines provided in the kit.
:
J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)