Christie J Series User Manual page 125

• Click the Test button to test the entered command string.
NOTE: If the test passed or failed, a green or red icon appears to the right side of the Test button as
shown.
10. Click Finish to create the added event.
NOTES: 1) The added event appears in the RTE Listing window. 2) To activate or deactivate one or
more RTEs listed in the RTE Listing window, select or clear each check box in the Active column
accordingly.
Add a System Event
1. Click Add to open the RTE Wizard.
2. Select the System Event tab.
3. Select a type of event from the System Event drop-down list.
NOTE: Depending on the selection made, additional selections are made available in the second drop-
down list located underneath (i.e. Input Change > Input 1, Slot 1)
Add a GPIO Event
1. Click Add to open the RTE Wizard.
2. Select the GPIO Event tab.
3. For the GPIO Event option define the Input
Condition field as required. The Input
Condition field contains 7 blocks which refer to
the 7 I/O pins on the GPIO connector. Pin 1 =
+12V and Pin 5 = Ground are not included or
changed. 2) Clicking a block toggles between H,
L, and X as shown. See
- GPIO Connector
J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)
2.5.9 System Integration
for detailed information.
Section 4: Web User Interface
.
4-11