Date And Time - Submenu; Menu Preferences - Submenu - Christie J Series User Manual

• Turn Off Image After (Min): This sets the activation interval (in minutes) for Auto Shutdown. If all
activity (input signals, web or serial port activity, key presses) is lost for this length of time, and Auto
Shutdown is enabled, an Auto Shutdown cycle will begin.
• Enter Standby After (Min): This sets the interval (in minutes) between starting Auto Shutdown and
entering Standby mode. Once Auto Shutdown has been entered, and all activity continues to be absent for
this interval, the projector will automatically enter power Standby mode.
• Lamp Regeneration Start Time: For 24/7 operation, the lamp regeneration cycle is required or lamp life
will be reduced. This control allows you to set the time of day (in 24 hour format) when the regeneration
cycle will start. In Dual Lamp mode, the cycle will be performed on each lamp separately. The second lamp
will wait for the first lamp to come back on before it begins the cycle. In single lamp mode, the projector will
go into Standby mode for the regeneration cycle. The regeneration cycle will run for 15 minutes for each
lamp. The lamp(s) must run for a minimum of 24 hours or the regeneration cycle will be skipped.
• Over-temp Fan Assist: When enabled, this option will cause all fans to come on at full speed if any enabled
thermal sensor has an over-temperature fault. This may help to prevent an emergency shutdown if the extra
cooling can bring the temperature within limits before the shutdown occurs. The fan assist will cause
increased noise levels due to the simultaneous full speed operation of all the fans. Normal operation will
resume when all over-temperature conditions are removed or fan assist is turned off.

3.9.5 Date And Time - Submenu

The current year-month-day, hour-minute-second. Changes here reset the projector real-time clock.

3.9.6 Menu Preferences - Submenu

Adjust the appearance, content and/or location of on-screen menus and messages.
• Large Menu Font: Enter a check mark to enlarge menus and their text. To adjust Menu Location to
accommodate the increased menu area.
• Menu Location: Use the pull-down list to choose a pre-defined default or customized location for the
display of all on-screen menus.
To create a custom menu location:
a. Choose a preset that is closest to the desired location.
b. Adjust Horizontal Shift and Vertical Shift slide bars to move the menu to the desired location.
NOTE: Avoid locations too close to a corner or edge to prevent cropping of larger menus.
• Horizontal Shift And Vertical Shift: Shift your menus as desired, creating a customized menu location.
• Display Automatic Message Boxes: Enable or disable the pop-up of automatic message boxes. These are
messages to the user that are not directly triggered by user actions. Examples are signal information, function
limitation or auto calibration message boxes.
• Display User Message Boxes: Enable or disable the pop-up of message boxes that are directly triggered by
user actions. Examples are gamma or lens control message boxes.
• Display Error Messages: Choose how you want to be notified of errors detected in either the incoming
signal or projector. Select Screen or All (default) to see brief on-screen messages. This is recommended
during setup or testing of the projector. Or select "Serial Ports" to receive messages via RS-232 or RS-422
serial communication only. To hide error message displays, such as during shows and presentations, select
Off or Serial Ports.
• Splash Screen Setup: Choose when to display a special introductory splash screen image, such as your
company logo, graphic or message.
• Always Off – A splash screen never appears
J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)
Section 3: Operation
3-33