Christie J Series User Manual page 22

Section 2: Installation and Setup
For 1900W and 2400W Models:
1. Connect the line cord of the projector to the AC receptacle at the AC inlet of the projector, then push the
wire clip over the plug to retain it, as shown.
For 3000W Model:
1. Remove the locking pin from the bracket surrounding the AC receptacle at the AC inlet of the projector by
pressing down on the button on the end of the locking pin, and then pull upwards on the pin to remove it.
2. Open the cap on the AC plug and line up the slot on the plug with the pin on the receptacle.
2-4 J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)