5.2
Replacing the Projection Lens
IMPORTANT! Remove the rear lens cap from the new lens. Keep the front lens cap on the lens to protect it
1. Rotate the lens clamp clockwise to the OPEN position.
2. Align the lens interface plate with the lens mount. Align the lens electrical connector with the mating
connector on the lens mount. Fully insert the assembly straight into the lens mount opening without
turning, as shown.
NOTE: When installing the lens, ensure that the lens is not inserted at an angle, as this can cause damage.
3. While holding the lens flat against the lens mount, rotate the lens clamp clockwise to lock the lens
assembly in place.
4. Remove the front lens cap.
J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)
during installation.
Section 5: Maintenance
5-5