Christie J Series User Manual page 96

Section 3: Operation
Adjust An Image For Keystone Correction
1. Enable keystone adjustments by selecting Keystone from the Geometry Correction drop down list.
NOTE: This will enable the controls for performing 1D or 2D keystone adjustments.
2. Select a test pattern.
NOTE: It is recommended to use the Grid test pattern.
3. Perform coarse keystone adjustment by using the Horizontal or Vertical Adjust setting. Use the left and
right arrow keys to make the adjustment.
NOTE: The corner cursors are a guide as to how the image will be adjusted. The outside edge of a cursor
will be the outside edge of the image. It may not be possible to exactly match the screen dimensions with
the Horizontal and Vertical Keystone controls, but these settings can be refined when the 2D keystone
settings are adjusted.
4. When adjustment of the corners is complete, select OK.
NOTE: A message will be displayed indicating that the projector is "Processing request". The settings are
applied to the displayed image, and will take approximately 10 seconds. If Vertical Keystone adjustments
have been made, starting to do any Horizontal Keystone adjustments will erase the Vertical settings, and
vice versa.
5. After the Horizontal or Vertical adjustments have been made, selecting 2D Keystone adjustments will
retain these settings. Fine adjustment can now be made by moving any single corner separately.
6. Use the arrow keys to move to the required corner.
NOTE: The current corner will be displayed in red.
7. Press E
NTER
NOTE: The current corner will be displayed in green.
8. Use the arrow keys to move the selected corner to match the screen.
9. Press E
NTER
10. Repeat Steps 6 to 9 to adjust all 4 corners until they match the screen.
11. Select OK to apply the new corner positions to the image.
NOTE: A message will be displayed for approximately 10 seconds indicating that the projector is
"Processing request".
Under certain combinations of extreme keystone co-ordinates and specific signal frequency, a keystoned image
may result that is outside the bandwidth limitations of the projector. When attempting to apply the keystone
settings, a message will pop up on the OSD, indicating that the bandwidth has been exceeded and the keystone
cannot be applied. The cursor co-ordinates for keystone adjustment will remain at the failed keystone position.
This will allow the user to make minor changes and attempt to reapply the corner settings. Either the co-
ordinates must be adjusted, or the free run frequency must be changed to fall within the allowed bandwidth.
The F
UNC ELP
+H
Blending and Black Level Blending features. This is helpful when, in some extreme keystone configurations,
some image corruption may appear and/or the menus may not be readable. Although F
these features, it will not overwrite their settings. If keystone is simply enabled again, the same image
corruption may occur. After pressing F
which will set all keystone co-ordinates to zero.
3-40
to select the corner.
again, to save that position for the corner.
key combination will immediately disable the Keystone, Brightness Uniformity, Edge
UNC
, it is recommend to immediately "Reset Keystone Settings",
ELP
+H
UNC ELP
+H disables
J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)